Automatic straight line edge banding hot melt adhesive

EVA Edge Banding Adhesive 88050

Suitable for different edge banding equipment, high cost performance: there are application products suitable for edge banding equipment with different requirements, with superior tensile strength, heat resistance, and low temperature resistance, and high cost performance. Color matching with board edges, customizable: there are different colors matching different board edge colors, making the edge banding line consistent with the board edge color, and customized color matching supply is also av

Product Highlights

EVA edge banding hot melt adhesive is a thermoplastic resin primarily made from EVA and used for edge banding in furniture manufacturing.

Applications

Suitable for various types of edge banding machines, edge banding of wood veneer, HPL, PVC, ABS and other edge banding strips on particle board or MDF and other wood-based panels, post-forming edge banding, etc.

Product Parameters

Color: Off-white Softening point/℃: 110±5 Viscosity 180℃/200℃: 110000±20000, 65000±10000 Application temperature: 180℃–210℃ Speed m/min: 15–40 Features and applicability: Low-filler high-temperature adhesive, fast melting, high tensile strength, good solvent resistance. Low consumption, high cost-effectiveness, suitable for higher-demand edgebanding and wrapping applications on wooden doors. Storage: 2 years in sealed packaging at 25℃. Store in a sealed condition in a clean, cool, dry place at temperatures between 5–30℃. When using, use the product with the longest storage time first.

Notes

Precautions	1. The edge banding surfaces to be bonded must be thoroughly cleaned, free from any dust or oil. Pressing must be tight to avoid insufficient or uneven pressure in any area. Regularly inspect the surface of the glue roller and remove impurities to ensure uniform adhesive application. 2. Frequently check and calibrate the temperature measuring device installed on the machine for any temperature deviation. 3. Coating must be uniform. The coating amount may be adjusted depending on the material type. Insufficient amount results in low edge banding strength, while excessive amount leads to visible glue lines and contaminates the machine and material surfaces. 4. When the ambient temperature is below 15°C, it is recommended to locally warm the edge banding surface and material to ensure bonding quality. 5. The feed speed must not be lower than 15m/min to prevent the adhesive from cooling down before pressure is applied. If it is necessary to operate at a low feed speed, the temperature of the glue roller must be increased, and the laminating materials must be preheated. 6. When the feed speed exceeds 25m/min, please increase the glue pot temperature to 210°C.
Operation and Use	Wear gloves and safety goggles each time this product is used. Ensure good ventilation and adequate local exhaust directly above the adhesive container and coating machine.
Cleaning	Generally considered hazardous waste. Allow residues to dry before sending out for disposal.
Health, Environmental Protection and Safety	Burns – Do not attempt to remove cooled adhesive from the skin. Seek medical guidance. Hot fumes – Do not inhale. Use in a well-ventilated area. Fire risk – Use within the recommended operating temperature.