Suitable for different edge banding devices with high cost-effectiveness
There are edge banding equipment application products suitable for different requirements, with superior tensile strength, heat resistance, and low temperature resistance, and high cost-effectiveness.
Color and board edge matching can be customized
There are different colors to match different board edge colors, making the edge banding line consistent with the board edge color, or customizing color matching supply.
Notes | 1. The edge sealing area should be cleaned thoroughly and free of any dust or oil stains. The pressing should be tight to avoid insufficient or uneven pressure in certain areas. Regularly inspect the surface of the glue roller, remove impurities, and ensure even glue application. 2. Regularly check and calibrate the temperature measuring device installed on the machine to see if there is any temperature deviation. 3. The coating should be uniform, and the coating amount will be adjusted according to the type of material. A small amount will result in insufficient edge strength, while a large amount will cause glue lines and dirty machine and material surfaces. When the room temperature is below 15 ℃, it is recommended to locally heat the sealing surface and sealing material to ensure the bonding quality. 5. The feeding speed should not be lower than 15m/min to avoid the glue liquid cooling down before pressurization. If it is necessary to work at a low feeding speed, the temperature of the glue roller must be increased, and the bonding material must be preheated first. When the feeding speed is greater than 25m/min, please increase the temperature of the glue box to 210 ℃. |
| Operation usage | Gloves and goggles should be worn every time the product is used. Ensure good ventilation and reasonable local exhaust above the glue bucket and glue coating machine. |
| clean | It is generally considered as hazardous waste. Dry the residue before sending it out for processing. |
| Health, Environmental Protection, and Safety | Burn - Do not attempt to remove the cooled adhesive that has adhered to the skin. Seek guidance from medical professionals. Hot smoke - do not inhale. Use in a well ventilated area. Fire risk - use at recommended operating temperatures. |
