Office Furniture

Solution Introduction

All solid wood, combined wood and board office furniture, simple board office furniture, screen matching series, high-end and atmospheric large desk series. Bookcases, filing cabinets series, and independent system of overall office furniture. Continuously highlighting the unique office environment culture.

IWG has over ten years of experience in providing comprehensive solutions for adhesive products, meeting the quality requirements of new processes and materials in the manufacturing of office furniture.

Integrated solution for adhesive used in office furniture, related processes, and recommended adhesives:

Common problem analysis

How to solve the problem of solid wood edge imprints after hot pressing 10mm solid wood edges and applying wood veneer for painting?

solution

The moisture content of solid wood edges should be controlled within 10%, and the shrinkage and expansion rate of solid wood edges should be well controlled;

After setting the solid wood edge, the thickness of the surface skin should be at least 1mm to prevent the above problems from occurring. The specific method is to first apply a layer of miscellaneous wood veneer, then apply the surface veneer with an additional layer of covering thickness, or apply a layer of balance board about 1mm first and then apply the surface veneer.

How to solve the problem of a very obvious adhesive line at the bonding point when sealing PVC edge strips on light colored countertops?

Root cause

• The color of the glue is not completely close to the color of the edges and panels, and there is a color difference that leads to obvious or black glue lines;

• When sealing the edge, if the amount of glue applied is too large or the viscosity of the glue itself is too high, the glue line at the bonding point will be thick and the glue line layer will be clearly visible;

• When cutting the panel, if there is a problem with the cutting tool, there will also be obvious glue lines due to edge breakage;

• If the opening time of the adhesive is too long and the edge is sealed under pressure, the slight rebound of the edge strip will also show a significantly thicker adhesive line.

Solution

• Test hot melt adhesive products that are completely similar in color to the panel edge strips or use laser edge banding technology to seal the edges;

• The parameters of the selected glue and the control parameters of the equipment are completely matched, and the amount of glue is adjusted to just meet the process standard of tensile strength;

• Ensure that the cutting tools used for cutting the board are sharp and the edges are cut without any breakage or damage;

• Select adhesive products that are suitable for the processing speed of edge banding equipment to ensure that the edge banding process has basically cured after the opening time of the pressure wheel.

Application Scenarios